When Switch Acts As Server For Password And Hwtacacs Authentication - H3C S5600 SERIES Operation Manual

Under Protocol options, select 2 from Preferred SSH protocol version. Then, click Open. If the
connection is normal, you will be prompted to enter the user name hello and the password. Once
authentication succeeds, you will log in to the server. The level of commands that you can access after
login is authorized by the CAMS server. You can specify the level by setting the EXEC Privilege Level
argument in the Add Account window shown in

When Switch Acts as Server for Password and HWTACACS Authentication

Network requirements
As shown in Figure
(SSH server) for secure data exchange. Password authentication is required.
The host runs SSH2.0 client software to establish a local connection with the switch.
The switch cooperates with an HWTACACS server to authenticate SSH users.
Network diagram
Figure 1-18 Switch acts as server for password and HWTACACS authentication
Configuration procedure
Configure the SSH server
# Create a VLAN interface on the switch and assign it an IP address. This address will be used as the IP
address of the SSH server for SSH connections.
<Switch> system-view
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ip address 192.168.1.70 255.255.255.0
[Switch-Vlan-interface2] quit
Generating the RSA and DSA key pairs on the server is prerequisite to SSH login.
# Generate RSA and DSA key pairs.
[Switch] public-key local create rsa
[Switch] public-key local create dsa
1-18, an SSH connection is required between the host (SSH client) and the switch
Figure 1-15.
1-29