[Sysname-GigabitEthernet1/0/1] stp disable
Configuring Leaf Nodes
Complete the following tasks to configure leaf nodes:
Enabling MSTP
Configuring an MST Region
Configuring How a Port Recognizes and Sends
MSTP Packets
Configuring the Timeout Time Factor
Configuring the Maximum Transmitting Rate on
the Current Port
Configuring the Current Port as an Edge Port
Configuring the Path Cost for a Port
Configuring Port Priority
Specifying Whether the Link Connected to a Port
Is Point-to-point Link
In a network containing switches with both GVRP and MSTP enabled, GVRP messages travel along
the CIST. If you want to advertise a VLAN through GVRP, be sure to map the VLAN to the CIST (MSTI
0) when configuring the VLAN-to-MSTI mapping table.
Configuration Prerequisites
The role (root, branch, or leaf) of each switch in each MSTI is determined.
Configuring the MST Region
Refer to
Configuring an MST
Configuring How a Port Recognizes and Sends MSTP Packets
Refer to
Configuring How a Port Recognizes and Sends MSTP
Configuring the Timeout Time Factor
Refer to
Configuring the Timeout Time
Task
Region.
Factor.
1-30
Remarks
Required
To prevent network topology jitter caused by
other related configurations, you are
recommended to enable MSTP after performing
other configurations.
Required
Optional
Optional
Optional
The default value is recommended.
Optional
Optional
Optional
Optional
Packets.