H3C S5600 SERIES Operation Manual page 589

The actual IP addresses of the master and the backups are 10.100.10.2 and 10.100.10.3
respectively.
The master is connected to the upstream network through its GigabitEthernet 1/0/1 port. The
backup is connected to the upstream network through its GigabitEthernet 1/0/2 port.
The virtual router IP address of the VRRP group is 10.100.10.1.
Enable the port tracking function on GigabitEthernet 1/0/1 port of the master and specify that the
priority of the master decreases by 50 when GigabitEthernet 1/0/1 port fails, which triggers new
master being determined in the VRRP group 1.
Network diagram
Figure 1-6 Network diagram for VRRP port tracking configuration
Vlan-int3
10.100.10. 2/24
Virtual IP address
202.38.160.111/24
Actual IP address
Vlan-int2
202.38.160. 1/24
Configuration procedure
Configure the master switch.
# Enter system view.
<Sysname> system-view
# Create VLAN 3.
[Sysname] vlan 3
[Sysname-vlan3] port GigabitEthernet1/0/1
[Sysname-vlan3] quit
# Configure VLAN-interface 3.
[Sysname] interface Vlan-interface 3
[Sysname-Vlan-interface3] ip address 10.100.10.2 255.255.255.0
[Sysname-Vlan-interface3] quit
# Create VLAN 2.
[Sysname] vlan 2
[Sysname-vlan2] port GigabitEthernet1/0/2
[Sysname-vlan2] quit
# Configure VLAN-interface 2.
Network
Master
Layer 2 Switch
Backup
Virtual IP address
202.38.160.111/24
Actual IP address
Vlan-int2
202.38.160.2/24
1-17