Configuring An Interface On The Local Switch To Send Ntp Messages; Configuring The Number Of Dynamic Sessions Allowed On The Local Switch - H3C S5600 SERIES Operation Manual

Configuring an Interface on the Local Switch to Send NTP Messages

Configuring the Number of Dynamic Sessions Allowed on the Local
Switch
Disabling an Interface from Receiving NTP Messages
Configuring an Interface on the Local Switch to Send NTP Messages
Follow these steps to configure an interface on the local switch to send NTP messages:
To do...
Enter system view
Configure an interface on the
local switch to send NTP
messages
If you have specified an interface in the ntp-service unicast-server or ntp-service unicast-peer
command, this interface will be used for sending NTP messages.

Configuring the Number of Dynamic Sessions Allowed on the Local Switch

A single device can have a maximum of 128 associations at the same time, including static associations
and dynamic associations. A static association refers to an association that a user has manually created
by using an NTP command, while a dynamic association is a temporary association created by the
system during operation. A dynamic association will be removed if the system fails to receive messages
from it over a specific long time.
In the server/client mode, for example, when you carry out a command to synchronize the time to a
server, the system will create a static association, and the server will just respond passively upon the
receipt of a message, rather than creating an association (static or dynamic). In the symmetric mode,
static associations will be created at the symmetric-active peer side, and dynamic associations will be
created at the symmetric-passive peer side; In the broadcast or multicast mode, static associations will
be created at the server side, and dynamic associations will be created at the client side.
Follow these steps to configure the number of dynamic sessions allowed on the local switch:
To do...
Enter system view
Configure the maximum
number of dynamic sessions
that can be established on the
local switch
Task
Use the command...
system-view
ntp-service source-interface
Vlan-interface vlan-id
Use the command...
system-view
ntp-service
max-dynamic-sessions
number
1-14
Remarks
Optional
Optional
Optional
Remarks
—
Required
Remarks
—
Required
By default, up to 100 dynamic
sessions can be established
locally.