Configuring Static Member Port For A Multicast Group - H3C S5600 SERIES Operation Manual

To do...
Enter system view
Enable unknown
multicast flooding
suppression
If the function of dropping unknown multicast packets or the IRF fabric function is enabled, you
cannot enable unknown multicast flooding suppression.
Unknown multicast flooding suppression and multicast source port suppression cannot take effect
at the same time. If both are enabled, only multicast source port suppression takes effect. In this
case, multicast data received on the blocked port will be dropped.

Configuring Static Member Port for a Multicast Group

If the host connected to a port is interested in the multicast data for a specific group, you can configure
that port as a static member port for that multicast group.
In Ethernet port view
Follow these steps to configure a static multicast group member port in Ethernet port view:
To do...
Enter system view
Enter Ethernet port view
Configure the current port as
a static member port for a
multicast group in a VLAN
In VLAN interface view
Follow these steps to configure a static multicast group member port in VLAN interface view:
To do...
Enter system view
Enter VLAN interface view
Configure specified port(s) as
static member port(s) of a
multicast group in the VLAN
Use the command...
system-view
igmp-snooping
nonflooding-enable
Use the command...
system-view
interface interface-type
interface-number
multicast static-group
group-address vlan vlan-id
Use the command...
system-view
interface vlan-interface
interface-number
multicast static-group
group-address interface
interface-list
6-11
Remarks
—
Required
By default, unknown multicast flooding
suppression
Remarks
—
—
Required
By default, no port is configured as
a static multicast group member
port.
Remarks
—
—
Required
By default, no port is configured
as a static multicast group
member port.