H3C S5600 SERIES Operation Manual page 51

To do...
Set the check
mode
Set the stop
bits
Set the data
bits
Configure the command level
available to users logging in to
the user interface
Make terminal services
available to the user interface
Set the maximum number of
lines the screen can contain
Set history command buffer
size
Set the timeout time for the
user interface
Note that if you configure to authenticate the users in the scheme mode, the command level available to
users logging in to a switch depends on the command level specified in the service-type terminal
[ level level ] command.
Use the command...
parity { even | none | odd }
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
user privilege level level
shell
screen-length screen-length
history-command max-size
value
idle-timeout minutes
[ seconds ]
2-12
Remarks
Optional
By default, the check mode of a
console port is set to none, that
is, no check bit.
Optional
The default stop bits of a console
port is 1.
Optional
The default data bits of a console
port is 8.
Optional
By default, commands of level 3
are available to users logging in to
the AUX user interface.
Optional
By default, terminal services are
available in all user interfaces.
Optional
By default, the screen can contain
up to 24 lines.
You can use the screen-length 0
command to disable the function
to display information in pages.
Optional
The default history command
buffer size is 10. That is, a history
command buffer can store up to
10 commands by default.
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.