Configuring Rapid Transition - H3C S5600 SERIES Operation Manual

Configuring Rapid Transition

Configuration prerequisites
As shown in Figure
operates as the downstream switch, and the latter operates as the upstream switch. The network
operates normally.
The upstream switch is running a proprietary spanning tree protocol that is similar to RSTP in the way to
implement rapid transition on designated ports. Port 1 is the designated port.
The downstream H3C switch is running MSTP. Port 2 is the root port.
Figure 1-8 Network diagram for rapid transition configuration
Configuration procedure
1) Configure the rapid transition feature in system view
Follow these steps to configure the rapid transition feature in system view:
To do...
Enter system view
Enable the rapid transition
feature
2) Configure the rapid transition feature in Ethernet port view
Follow these steps to configure the rapid transition feature in Ethernet port view:
To do...
Enter system view
Enter Ethernet port view
Enable the rapid transition
feature
1-8, a H3C series switch is connected to another manufacturer's switch. The former
Use the command...
system-view
stp interface interface-type
interface-number
no-agreement-check
Use the command...
system-view
interface interface-type
interface-number
stp no-agreement-check
1-43
Remarks
—
Required
By default, the rapid transition
feature is disabled on a port.
Remarks
—
—
Required
By default, the rapid transition
feature is disabled on a port.