H3C S5600 SERIES Operation Manual page 62

To do...
Set the timeout time for the
user interface
Note that if you configure to authenticate the users in the scheme mode, the command level available to
the users logging in to the switch depends on the user privilege level level command and the
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] } command, as listed in
3-4.
Table 3-4 Determine the command level when users logging in to switches are authenticated in the
scheme mode
Authentication
mode
authentication-m
ode scheme
[ command-auth
orization ]
VTY users that
are
AAA&RADIUS
authenticated or
locally
authenticated
VTY users that
are authenticated
in the RSA mode
of SSH
Use the command...
idle-timeout minutes
[ seconds ]
Scenario
User type
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
The user privilege level level
command is executed, and the
service-type command does not specify
the available command level.
The user privilege level level
command is executed, and the
service-type command specifies the
available command level.
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
The user privilege level level
command is executed, and the
service-type command does not specify
the available command level.
3-9
Remarks
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Command
Table
Command
level
Level 0
Determined by
the service-type
command
Level 0
Determined by
the service-type
command
Level 0
Determined by
the user
privilege level
level command