H3C S5600 SERIES Operation Manual page 251

You can determine whether or not the link connected to a port is a point-to-point link in one of the
following two ways.
Specify whether the link connected to a port is point-to-point link in system view
Follow these steps to specify whether the link connected to a port is point-to-point link in system view:
To do...
Enter system view
Specify whether the link
connected to a port is
point-to-point link
Specify whether the link connected to a port is point-to-point link in Ethernet port view
Follow these steps to specify whether the link connected to a port is point-to-point link in Ethernet port
view:
To do...
Enter system view
Enter Ethernet port view
Specify whether the link
connected to a port is a
point-to-point link
If you configure the link connected to a port in an aggregation group as a point-to-point link, the
configuration will be synchronized to the rest ports in the same aggregation group.
If an auto-negotiating port operates in full duplex mode after negotiation, you can configure the link
of the port as a point-to-point link.
After you configure the link of a port as a point-to-point link, the configuration applies to all the MSTIs the
port belongs to. If the actual physical link of a port is not a point-to-point link and you forcibly configure
the link as a point-to-point link, loops may occur temporarily.
Configuration example
# Configure the link connected to GigabitEthernet 1/0/1 as a point-to-point link.
1) Perform this configuration in system view
<Sysname> system-view
[Sysname] stp interface GigabitEthernet 1/0/1 point-to-point force-true
2) Perform this configuration in Ethernet port view
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp point-to-point force-true
Use the command...
system-view
stp interface interface-list
point-to-point { force-true |
force-false | auto }
Use the command...
system-view
interface interface-type
interface-number
stp point-to-point { force-true
| force-false | auto }
1-28
Remarks
—
Required
The auto keyword is adopted
by default.
Remarks
—
—
Required
The auto keyword is adopted
by default.