Table of Contents
Advertisement
Baffle pin
Baffle pin hole
Figure 33. DIMM air baffle installation
Step 2.
Install the cover.
Step 3.
Slide the server into the rack.
Step 4.
Reconnect the power cord and any cables that you removed.
Step 5.
Turn on the peripheral devices and the server.
Attention: For proper cooling and airflow, replace the air baffle before turning on the server.
Operating the server with an air baffle removed might damage server components.
Removing a memory module
Use this information to remove a memory module.
To remove a dual inline memory module (DIMM), complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords.
Step 3.
Remove the cover (see
Step 4.
Remove the DIMM air baffle (see
Step 5.
Carefully open the retaining clips on each end of the DIMM connector and remove the DIMM.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and
close the clips gently.
"Safety" on page v
"Removing the cover" on page
"Removing the DIMM air baffle" on page
DIMM air baffle
and
"Installation guidelines" on page
424).
428).
.
Chapter 5
Removing and replacing components
429
Advertisement
Table of Contents
