Stylus Photo R300/R310
2.3.5 Removing Panel Board
External View
C.B.P 3x8 (4-6kgf•cm)
Panel Board
LCD Panel
Rib and
Adjusting Hole
Shield Plate, LCD
C.B.S 3x8 (4-6kgf•cm)
Figure 2-12. Removing "Panel Board"
DISASSEMBLY AND ASSEMBLY
Board Assy., Panel
2
4
1
3
Line Mark
Two-sided
Tapes
Cover, LCD
Switch
Parts/Units which should be removed before removing "Panel Board"
Paper Support Assy./Housing, Upper
Procedure for Removing
1.
Remove the screws (x4) which secure "Board Assy., Panel". Then, remove
"Board Assy., Panel".
2.
Remove the screw which secures "Panel Board". Then, remove "Panel Board"
from "Shield Plate, LCD".
3.
Take off the two-sided tapes (x2) which secure "Cover, LCD" from the back
of "Housing, Upper". Then, remove "Cover, LCD".
Do not damage "LCD Panel".
When removing "Panel Board Unit", the switch may detach and
drop. If this occurs, reinstall it referring the figure.
When looking at back side of "Housing, Upper", make sure that
the line mark of "Housing, Upper" securely comes to the position
shown in the figure.
Match the rib of "Shield Plate, LCD" and the positioning hole of
"Panel Board".
Screw "Board Assy., Panel" in the order as shown in the figure.
Disassembly
Revision A
44