Figure 11 Adapting The Arm Rest To The Upper; Figure 12 Adapting The Arm Rests To The Forearm Length - Otto Bock C1000 DS Instructions For Use Manual

Adapting the arm rests to the upper arm length
1. Loosen the Allen head screw using an Allen wrench
size 3.
2. Move the side panel with arm rest up or down along
the rail into the desired position.
3. Retighten the Allen head screw.
Figure 11 Adapting the arm rest to the upper arm length
C1000 DS
Adapting the arm rests to the forearm length
1. Loosen the two Allen head screws on the underside of
the arm rest using an Allen wrench size 3. Three set
screws must be loosened on the side where the control
panel is attached (see Figure 12).
2. Move the arm rest with the control panel holder or re-
placement tube forward or backwards to the desired
position along the attachment rail.
3. Retighten all set screws.
Figure 12 Adapting the arm rests to the forearm length
Operation
Ottobock 161
|