Figure 3 Fuse - Otto Bock C1000 DS Instructions For Use Manual

Delivery and preparation for use
To do so, remove the fuse from the protective cover on the
control panel, open the cover of the fuse holder and insert
the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it is not positioned at an angle.
Close the cap until you feel it snap back into place.
Figure 3 Fuse
1 Cap of fuse housing, open
2 Fuse
152 Ottobock
|
Initial operation with electrical back angle adjustment
CAUTION
Risk of accidents and injury due to an incorrectly in-
stalled back rest. Ensure that the locking mechanism en-
gages in the cross bolt. Verify that the cross bolt and lock-
ing mechanism are securely in place.
Folding up the back rest:
1. Fold the back rest up.
1
2. Insert the cross bolt at the end of the drive unit into the
holder.
2
3. Push the lever down. The locking system engages in
the cross bolt.
C1000 DS