Figure 45 Illustration Of Pressure Points - Otto Bock C1000 DS Instructions For Use Manual

Accessories
Figure 45 Illustration of pressure points
Removing the Recaro seat from the mobility base
„ Loosen the left and right locking bolts on the seat frame.
To do this, pull the release strap under the seat bottom
forward and hold it (see Fig. 46, item 1).
„ To release the posterior seat adapter from the retainer
bushings, slightly tilt the seat to the rear and slide it
back a little.
„ Remove the Recaro seat.
206 Ottobock
|
Attaching the Recaro Seat to the Chassis
CAUTION
Risk of injury if the locking bolts are not engaged. When
mounting the Recaro seat, the seat adapter must be se-
curely attached to the retainer bushings. The anterior lock-
10
1 0
ing bolts have to snap into place up to the key ring.
180
„ Place the posterior edge of the Recaro seat on the end
of the seat frame.
„ Slide the seat forward until the posterior seat adapter
hangs in the retainer bushings.
„ Tilt the seat ahead until the locking bolts engage with
the seat frame up to the key ring (see Fig. 46, item 2).
CAUTION
cure locking.
Visually inspect and shake the seat to ensure se-
C1000 DS