Preparing For Transportation; Figure 6 Folding The Back Rest; Figure 7 Folding Size - Otto Bock C1000 DS Instructions For Use Manual

Transportation and storage

5.2.1 Preparing for transportation

For the purpose of transportation, the size of the wheelchair
can be reduced by folding the footplates up or removing them,
removing the side panels and folding down the back rest.
Before transporting the power wheelchair, switch off the
control unit and engage the wheel lock.
Folding the back rest
1. Remove the side panels (see Section 6.1.3).
2. Pull the release strap to the rear.
3. With your hand, fold the back rest down onto the seat
bottom.
Figure 6 Folding the back rest
156 Ottobock
|
Folding the back rest with electric back angle adjustment
1. Remove the side panels (see Section 6.1.3).
2. Unlock the cross bolts on the lower end of the drive unit
by pushing the lever up (see Section 4.3 "Initial opera-
tion", Figure 4).
3. Remove the cross bolt from the holder.
4. With your hand, fold the back rest down onto the seat
bottom.
Figure 7 Folding size
Prior to operating the power wheelchair with back angle
adjustment, proceed in the reverse sequence.
C1000 DS