Advanced Settings For Printing And Cutting With Crop Marks; Aligning Positions Manually - Roland TrueVIS VG-640 User Manual

Advanced Settings for Printing and Cutting with Crop Marks

Aligning Positions Manually

Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks
cannot be detected automatically, perform alignment manually.
The following figure is given as an example to explain how to manually set the base point and align points.
M E M O
The numbers for align points are determined with reference to the location of the base point, as
shown in the following figure. You cannot set the align points unless you specify the base point.
Redoing the setting for the base point clears any align points that have been set.
Crop mark
(Align point 3)
Crop mark
(Align point 1)
4
1.
Set the base point.
A
Press [ ], [ ], [ ], or [ ] to move the center of the blade to the "base point" position.
B
Press [FUNCTION] to display the screen shown on the left.
FUNCTION
BASE POINT
C
Press [ENTER].
The [BASE POINT] is set. The character "B" is displayed on the screen.
W1100mm
B
146
Crop mark
(Align point 2)
Crop mark
(Base point)
Crop mark
(Base point)