Step 3 : Batch Settings - Roland TrueVIS VG-640 User Manual

D
Set the correction values from "H1" to "H4."
1
Press [ ] or [ ] to select a value from H1 to H4.
H1 H2 H3
0 0
2
Press [ ] or [ ] to select the correction value.
H1 H2 H3
0 0
3 When you have finished setting the correction values, press [ENTER].
The screen shown below appears again.
DETAIL SETTING
SETTING NO.1
E
Press [ ] to display the screen shown below.
DETAIL SETTING
SETTING NO.2
F
Set the correction values from "BI-DIR NO.2 H1" to "BI-DIR NO.2 H4" in the same
manner as step
D
1
G
Repeat step to check whether the correction was successful.
For all the correction values, check that the misalignment is minimized for the two vertical lines
indicated by " " (that is, the current correction value). If the misalignment is smaller for another
set of vertical lines, set the correction values again.
H
When you have successfully performed the correction, press [MENU] to go back to
the original screen.

Step 3 : Batch Settings

To ensure the optimal output according to the media size and type, you can configure various settings on this
machine. However, it is hard work to configure these settings one at a time. You can use the "MEDIA SETTING"
menu to configure the absolute minimum of necessary items as a batch. You can save the setting details as
a preset.
Note that you can set all the items set here individually as well.
1.
Start the "MEDIA SETTING" menu.
A
Load the media.
Check that the media is not sagging. If any sagging exists, settings such as the correction values
will not function effectively.
" P. 29, "Step 1 : Loading Roll Media (Setup of Media)"
H4
0 0
H4
0 0
.
, P. 72, "Loading Sheet Media (Setup of Media)"
Basic Printing Method
39
2