Roland TrueVIS VG-640 User Manual page 50

Basic Printing Method
J
Press [ENTER] to confirm your entry.
If you select "YES," the test pattern (P&C1) is printed and cut again. Go back to step
the setting again.
If you select "DONE," proceed to the next procedure.
9.
Correct the misalignment of the printing and cutting positions when using crop
marks. (Separate setting "
2
M E M O
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may
be misaligned even when you are using crop marks depending on the composition of the media.
A
Press [ ] or [ ] to select "NEXT" or "SET."
Select "NEXT" when you will not print crop marks. Select "SET" when you will print crop marks.
CROP-CUT ADJ.
[SET]
B
Press [ENTER] to confirm your entry.
If you select "SET," the test pattern (C&C1) is printed and cut. Proceed to the next procedure.
If you select "NEXT," proceed to step
C
Check the test pattern
Check for misalignment in the cutting position and printing position.
D
<Cutting position and printing position are not aligned>
Press [ ] to select "YES."
CONTINUE ADJ.?
[YES] DONE
<Cutting position and printing position are aligned>
Press [ ] to select "DONE."
CONTINUE ADJ.?
YES [DONE]
48
P.148
NEXT
10
condition.
(C&C1)
Printing position and cutting
position are misaligned.
)
.
Cutting position
Printing position
Printing position and cutting
position are aligned.
G and perform