Drying Time - Roland TrueVIS VG-640 User Manual

Basic Printing Method
J
Press [ENTER] to confirm your entry.
If you select "YES," the test pattern (C&C1) is printed and cut again. Go back to step
the setting again.
If you select "DONE," proceed to the next procedure.
10.
Set the drying method and time after printing. (Separate setting "
2
A
Press [ ] or [ ] to select "ENABLE" or "DISABLE."
FEED FOR DRY
DISABLE ENABLE
Current
setting
M E M O : D ry i ng M e t h o d a f t e r P r in t i n g
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer
after the 1st page is printed. To make sure to dry the entire printed area, select "ENABLE." If "DISABLE"
is selected, the trailing edge of the printing area is not fed to the dryer unless you continue with a
subsequent printing operation.
B
Press [ENTER] to confirm your entry.
C
Press [ ] or [ ] to set the drying time.

DRYING TIME

10min
Current
setting
M E M O : D ry i ng Tim e a f t e r Pr in t in g
Set the drying time after the 1st page is printed. The next operation is not started until the set time
passes.
M E M O : E x am p le o f S e t t in g Ti m e ( Ge n e r a l Gui de)
The setting time varies according to the settings such as the type of media and the printing quality.
Condition: Non-coated vinyl chloride media
Setting time: About three minutes
D
Press [ENTER] to confirm your entry.
50
Setting after
change
10min
Setting after
change
G and perform
)
P.120