Correcting The Misalignment Of Printing And Cutting With Crop Marks (Concurrent Test For Printing And Cutting With Crop Marks); Correcting The Misalignment Of Printing And Cutting With Crop Marks (Concur- Rent Test For Printing And Cutting With Crop Marks); Correcting The Misalignment Of Printing And Cutting With Crop Marks - Roland TrueVIS MG-640 User Manual

Accurately Adjusting the Settings for Cutting with Crop Marks
Correcting the Misalignment of Printing and Cutting with Crop Marks (Concur-
rent Test for Printing and Cutting with Crop Marks)
Depending on the composition of the media, the positioning of printing and cutting may be misaligned
even when you are using crop marks. Make corrections for misaligned printing and cutting for the media
you are using.
In cutting with crop marks, cutting is performed after removing the media after printing. However, with
this method, you can make corrections of printing and cutting positions at the same time without removing
the media.
1. Adjust the misalignment of the ink landing position.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the following screen.
MENU
MEDIA GAP ADJ.
3.
Press [▶] to display the following screen.
MEDIA GAP ADJ.
TEST PRINT
4.
Press [ENTER].
Printing of the test pattern starts.
5.
When printing is finished, press [▼], then [▶] to display the screen shown below.
SIMPLE SETTING
0
6.
View the printed test pattern, and then determine the correction value.
Select the value that gives the least misalignment between the two lines. In the case of the fol-
lowing figure, select "-3." When you cannot choose between two sequential numbers, select a val-
ue that is between them (you can set correction values in units of "0.5").
7.
Press [▲] or [▼] to select the correction value.
8.
Press [ENTER] to confirm your entry.
9.
Press [◀][▲] to display the following screen.
176
Optimizing the Output Quality
0