A Message Appears - Roland TrueVIS VG-640 User Manual

A Message Appears

These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any errors. Follow the prompts and take action accordingly.
Message
[1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6
■ 7 ■ 8 ■]
[CLOSE THE COVER
(FRONT COVER/
COVER L/COVER R)]
[PRESS THE POWER
KEY TO CONTINUE]
[SHEET NOT
LOADED
SETUP SHEET]
[CLOSE
SLOT COVER]
[END OF THE SHEET]
[EMPTY
DRAIN BOTTLE]
[INSTALL
DRAIN BOTTLE]
[NOW
HEATING...]
[REMOVE
MEDIA CLAMPS]
[TIME FOR
MAINTENANCE]
[TIME FOR
WIPER REPLACE]
Situation/cause
Only a small amount of ink
remains.
The front, left, or right cover is
open. For safety, the carriage
does not operate while a cover
is open.
The cover was closed after
[CLOSE THE COVER (FRONT
COVER/COVER L/COVER R)] was
displayed.
This message appears when an
attempt to perform a printing
test was made while no media
was loaded.
This message appears if the ink
slot cover is open when output
starts.
The trailing edge of the media
was detected during operation.
This appears when a certain
amount of discharged fluid
collects in the drain bottle.
Check whether the drain bottle
is installed correctly.
The media heating system did
not reach the set temperature.
Wait until the set temperature
is reached.
This appears if the media
clamps are attached when
cutting off the media.
It is time to perform manual
cleaning.
It is time to replace the wiper.
Action
Replace the ink pouch indicated by the flashing
number with a new one.
Close the front, left, or right cover.
Press [ENTER]. The machine will continue its oper-
ation.
Load media.
Close the ink slot cover.
Press any key on the operation panel to clear the
message. Load new media.
Discard the discharged fluid in the bottle.
" P. 81 "When "EMPTY DRAIN BOTTLE" Is Displayed"
Install the drain bottle, and then press [ENTER].
" P. 82 "Disposing of Discharged Fluid"
Printing starts when [HEATER] lights. You can stop
printing by holding down [PAUSE] for one second or
longer while this is displayed. Pressing [PAUSE] makes
printing start immediately, without waiting to reach
the set temperature.
Open the front cover, remove the right and left media
clamps, and then press [ENTER].
After verifying the message, press [ENTER], and then
perform manual cleaning.
" P. 87 "Manual Cleaning"
After verifying the message, press [ENTER], and then
replace the wiper.
" P. 99 "Replacing the Wiper"
6
185