Roland TrueVIS VG-640 User Manual page 45

5.
Perform the correction for misalignment in bidirectional printing. (Separate setting "
A
Press [ ] to select "SET."
ADJUST BI-DIR.
[SET] NEXT
B
Press [ENTER] to confirm your entry.
The test pattern of bidirectional correction is printed.
You can select "NEXT" and press [ENTER] to proceed to the next menu.
C
Press [ENTER].
INPUT
ADJ. VALUES
D
View the printed test pattern, and then determine the correction values.
Select the value that gives the least misalignment between the two lines. In the case of the following
figure, select "+5." When you cannot choose between two sequential numbers, select a value that
is between them (you can set correction values in units of "0.5").
E
Press [ ] or [ ] to select the correction value.
ADJUST BI-DIR.
0
F
Press [ENTER] to confirm your entry.
G
Press [ ] to select "YES."
REDO ADJ.?
[YES] DONE
5
Basic Printing Method
)
P.124
43
2