Performing Printing And Cutting Separately; To Perform Printing And Cutting Separately; Printing With Crop Marks - Roland LEC-540 User Manual

Performing Printing and Cutting Separately

To Perform Printing and Cutting Separately

You can remove the printed media and then reload it and perform cutting.
Then, carry out alignment to prevent misalignment of the printing results and the cut lines. Perform this
adjustment in the next Procedure.
Procedure

Print with Crop Marks.
 P. 144, "Printing with Crop Marks"

Align to the printed crop marks and perform cutting.
You can detect the crop marks automatically or manually.
 P. 146, "Aligning Automatically and Cutting," p. 148, "Aligning Manually and Cutting"
Note: Correct misalignment of the printing and cutting positions, if applicable.
 P. 149, "Correcting Misalignment for Printing and Cutting When Using Crop Marks"

Printing with Crop Marks

Use your software RIP to make the settings for printing crop marks. For information on how to make the set-
ting, refer to the documentation for the software RIP you're using.
5
Alignment marks and symbols drawn using a graphics program cannot be used as crop marks.
The crop marks are printed as shown in the figure.
Crop Mark
(Align point 3)
Crop Mark
(Align point 1)
144
Crop Mark
(Align point 2)
Crop Mark
(Base point)