Performing Printing and Cutting Separately
To Perform Printing and Cutting Separately
You can remove the printed media and then reload it and perform cutting.
(Example: Perform lamination or other processing after printing, then reload the media and perform cutting.)
Then, carry out alignment to prevent misalignment of the printing results and the cut lines. Perform this
adjustment in the next Procedure.
Procedure
Printing with Crop Marks.
P.35, "Printing with Crop Marks"
Align to the printed crop marks and perform cutting.
P.37, "Aligning Automatically and Cutting"
Printing with Crop Marks
This section describes how to specify settings when using the BN-20 driver. When using Roland VersaWorks,
refer to the "Roland VersaWorks Quick Start Guide"
*You cannot make this setting using the BN-20 driver on a white ink model. Use Roland VersaWorks.
Media Sizes Allowing Automatic Crop Mark Detection
1.4 mm
Crop Mark
65 mm or more
22.5 mm
Printable area
22.5 mm
60 mm or more
Chapter 2 Fully Utilizing the Machine
Pinch rollers
1.4 mm
35