Roland TrueVIS VG-640 User Manual page 11

No.
6
Media clamp
7
Grit patterns
8
Blade protector
9
Platen
0
Apron
⑪
Wiper
B
Wiper tray
C
Waste valve
Serious Errors Indicated by the Print Light
If an error that may lead to serious damage to the printer occurs, the print light blinks in red.
This indicates one of the situations shown below.
When the print light blinks in red, the error also appears on the operation panel's display screen. Check the
display screen, and then respond to the error according to the information in P. 187 "An Error Message Ap-
pears" in this manual.
Display screen
AVOIDING DRY-UP TURN POW-
ER OFF
MOTOR ERROR TURN POWER
OFF
TEMPERATURE IS TOO LOW
**°C
TEMPERATURE IS TOO HIGH
**°C
CANCELED FOR PUMP PRO-
TECTION
SERVICE CALL xxxx
Name
The print heads were about to dry out. The print heads may be dam-
aged if allowed to dry out.
An excessive load was applied to the motor. If this error is not ad-
dressed, the print heads may be damaged.
The ambient temperature in the printer's installation location has
fallen below the temperature in which operation is possible. If this
error is not addressed, the printer may malfunction.
The ambient temperature in the printer's installation location has risen
above the temperature in which operation is possible. If this error is
not addressed, the printer may malfunction.
An excessive load was applied to the pump within the machine. If this
error is not addressed, the pump may malfunction.
An unrecoverable error or an error that requires a part replacement
has occurred.
Part Names and Functions
Function overview
This clamps the edge of the media to keep it from
coming loose. It also prevents fuzz on the cut
edge of the media from touching the print heads.
These indicate the locations of the grit rollers. When
loading media, be sure to place the pinch rollers
within the ranges indicated by these patterns.
This is the path that the blade takes during cut-
ting. It protects the tip of the blade.
This is the path over which the media passes. A suc-
tion fan that keeps the media from coming loose
and a print heater that helps fix the ink are built in.
This has a built-in dryer to speed up drying of the ink.
Cleans the print heads during automatic cleaning
and in similar situations.
This tray houses the wiper cleaning liquid used
to clean the wiper. It contains three tray pads.
Open this valve to drain the discharged fluid that
has collected in the wiper tray.
Error overview
1
9