Roland TrueVIS VG-640 User Manual page 152

Advanced Settings for Printing and Cutting with Crop Marks
F
Set the correction values for the feed direction "F" and the scan direction "S."
1
Press [ ] or [ ] to set the correction value for the feed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2 Press [ ] or [ ] to set the correction value for the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 When you have finished setting the correction values, press [ENTER].
G
Press [MENU], then [ ] to display the screen shown below.
CROP-CUT ADJ.
TEST PRINT
H
Press [ENTER].
The test pattern (C&C1) is printed and cut. If the printing and cutting lines are aligned, adjustment
is complete. If further adjustment is needed, press [ ] then [ ] to go back to step
the adjustment.
4
Description
Depending on the composition of the media, the positioning of printing and cutting may be misaligned even
when you are using crop marks. Make corrections for misaligned printing and cutting for the media you are
using.
Default Settings
[F] (correction value of the media feed direction): 0.00 mm
[S] (correction value of the cutting carriage movement direction): 0.00 mm
150
F
and fine-tune