Page 1
5. Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur with respect to any article made using this function.
Page 2
To Ensure Safe Work About Notices. Used for instructions intended to alert the operator to the risk of death or severe injury should the unit be used improperly. Used for instructions intended to alert the operator to the risk of injury or material damage should the unit be used improperly.
About the Labels Affi xed to the Unit These labels are affi xed to the body of this product. The following fi gure describes the location. Caution: Pinching Hazard Be careful not to allow the fi ngers to become pinched when loading media or closing covers.
Page 4
Limit Position & Cut Down Position Initialize This function may solve one of the following errors or problem by re-setting the Limit Position and Cut Down Position. - Service Call 0101, 0103, 0105, or 0106 - Scan Motor Error - Separating knife doesn't go down when Sheet Cut Function is performed Procedure Remove the Right Cover.
Page 5
Confirm that the head is capped properly, and press [ENTER] key. SETTING UP The Tool Carriage will be separated from the Head Carriage and THE LIMIT the limit position initialize will start. After initialize is completed, the message is displayed. DETECTING..