Roland TrueVIS VG-640 User Manual page 64

Basic Settings for Cutting
C
Peel off the cut shapes to verify the cutting quality.
2
<Two shapes are peeled off separately>
You do not need to perform the setting because the blade force is appropriate.
<Two shapes are peeled off together/backing paper is also cut>
Proceed to the next step to set the blade force.
D
Press [ ] or [ ] to select a value.
<Two shapes are peeled off together>
Raise the blade force.
<Backing paper is also cut>
Reduce the blade force.
E
Press [ENTER] to confirm your entry.
F
Press [FUNCTION] to go back to the original screen.
G
Repeat step
At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade
force. Refer to the following page.
" P. 135, "Fine-tuning the Cutting Conditions"
62
1
to check whether the correction was successful.