Roland TrueVIS VG-640 User Manual page 48

Basic Printing Method
8.
Correct the misalignment of the printing and cutting positions. (Separate setting "
M E M O
Subtle misalignment between the printing and cutting positions may occur due to the thickness
of the media or the head height. We recommend that you make corrections to match the media
you are using.
2
A
Press [ ] to select "SET."
PRINT-CUT ADJ.
[SET]
B
Press [ENTER] to confirm your entry.
The test pattern (P&C1) is printed and cut. The test pattern is printed at three locations on the media:
at the two edges and in the center.
You can select "NEXT" and press [ENTER] to proceed to the next menu.
C
Check the test pattern (P&C1).
Check for misalignment in the cutting position and printing position.
D
<Cutting position and printing position are not aligned>
Press [ ] to select "YES."
CONTINUE ADJ.?
[YES] DONE
<Cutting position and printing position are aligned>
Press [ ] to select "DONE."
CONTINUE ADJ.?
YES [DONE]
E
Press [ENTER] to confirm your entry.
If you select "YES," the test pattern (P&C2) for setting the correction values is printed and cut. Pro-
ceed to the next procedure.
If you select "DONE," proceed to step
46
NEXT
Printing position and cutting
position are misaligned.
Cutting position
Printing position
Printing position and cutting
position are aligned.
9
.
)
P.139