Roland TrueVIS VG-640 User Manual page 49

F
Press [ENTER].
INPUT
ADJ. VALUES
G
Check the correction values from the test pattern (P&C2) condition.
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction (the direction of print head movement) and the feed direction (the media feed
direction).
Correction-value scale
Feed direction
H
Set the correction values for the feed direction "F" and the scan direction "S."
1
Press [ ] or [ ] to set the correction value for the feed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2 Press [ ] or [ ] to set the correction value for the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 When you have finished setting the correction values, press [ENTER].
The test pattern (P&C1) is printed and cut again. Check the condition of the test pattern to check
whether the printing position and the cutting position are aligned.
I
<Cutting position and printing position are not aligned>
Press [ ] to select "YES."
REDO ADJ.?
[YES] DONE
<Cutting position and printing position are aligned>
Press [ ] to select "DONE."
REDO ADJ.?
YES [DONE]
Scan direction
Cutting line
Basic Printing Method
Cutting line
In this case, the
correction value
is "-0.3."
2
47