Roland TrueVIS VG-640 User Manual page 44

Basic Printing Method
D
View the printed test pattern, and then determine the correction values.
Select the value to make the gap and overlap between the upper/lower squares smallest. In the case
of the following figure, select "-0.40." When you cannot choose between two sequential numbers,
specify a value that is between them.
2
E
Press [ ] or [ ] to select the correction value.
CALIBRATION
0.00%
F
Press [ENTER] to confirm your entry.
G
Press [ ] to select "YES."
REDO ADJ.?
[YES]
H
Press [ENTER] to confirm your entry.
The test pattern is printed again. Check that the gap and overlap are the smallest for the figure in-
dicated by "
figure, return to step
If you do not need to change the correction value, press [ENTER] again.
I
Press [ ] to select "DONE."
REDO ADJ.?
YES
J
Press [ENTER] to confirm your entry.
42
Gap present
+0.05%
DONE
" (that is, the current correction value). If the gap and overlap are smaller for another
E to perform the setting again.
[DONE]
= Current correction value
Overlap