Roland TrueVIS VG-640 User Manual page 46

Basic Printing Method
H
Press [ENTER] to confirm your entry.
The test pattern is printed again. Check that the misalignment is minimized for the two vertical lines
indicated by "
set of vertical lines return to step
If you do not need to change the correction value, press [ENTER] again.
I
Press [ ] to select "DONE."
2
REDO ADJ.?
YES
J
Press [ENTER] to confirm your entry.
6.
Decide to perform the setting for cutting or not.
A
Press [ ] or [ ] to select "NEXT" or "SET."
Select "NEXT" when you will only perform printing. Select "SET" when you will perform cutting
(including printing and cutting as well as crop mark printing and cutting).
CUT CONFIG
[SET]
B
Press [ENTER] to confirm your entry.
If you select "SET," proceed to the next procedure.
If you select "NEXT," proceed to step
7.
Set the blade force. (Separate setting "
M E M O
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust
the blade force.
A
Press [ ] to select "SET."
CUT FORCE
[SET]
B
Press [ENTER] to confirm your entry.
The test pattern is cut.
You can select "NEXT" and press [ENTER] to proceed to the next menu.
44
" (that is, the current correction value). If the misalignment is smaller for another
E to perform the setting again.
[DONE]
NEXT
10
NEXT
.
)
P.135