Roland TrueVIS VG-640 User Manual page 142

Advanced Cutting Settings
C
Press [ ] to display the screen shown below.
CUTTING MENU
PRINT-CUT ADJ.
D
Press [ ] to display the screen shown below.
PRINT-CUT ADJ.
TEST PRINT
E
Press [ENTER].
The test pattern (P&C1) is printed and cut. The test pattern is printed at three locations on the media:
at the two edges and in the center.
F
Check the test pattern (P&C1).
Check whether the printing position and the cutting position are aligned.
4
If the printing position and the cutting position are aligned, no corrections are necessary.
If the printing position and the cutting position are not aligned, proceed to the next procedure.
3.
Set the correction values.
A
Press [ ] twice to display the screen shown below.
PRINT-CUT ADJ.
TEST PRINT 2
B
Press [ENTER].
The test pattern (P&C2) is printed and cut.
C
Press [ ] to display the screen shown below.
PRINT-CUT ADJ.
SETTING
140
Printing position and cutting
position are misaligned.
Cutting position
Printing position
Printing position and cutting
position are aligned.