Roland TrueVIS VG-640 User Manual page 147

G
Set the correction values for the feed direction "F" and the scan direction "S."
1
Press [ ] or [ ] to set the correction value for the feed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2 Press [ ] or [ ] to set the correction value for the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 When you have finished setting the correction values, press [ENTER].
H
Press [PAUSE] to display the screen shown below.
TO CANCEL
DOWN PAUSE KEY
I
Press [PAUSE] again to restart the cutting operation.
At this time, holding down [PAUSE] for one second or longer cancels the cutting operation.
"
P. 77 "Pausing or Canceling Output"
Description
With this machine, you can pause a cutting operation to correct the misalignment of the printing and cutting
positions. The correction values set here are applied as the default values of the printing and cutting positions.
If the printing and cutting positions are misaligned, you normally adjust the positions while checking a test
pattern.
P. 139 "Correcting the Misalignment of the Printing and Cutting Positions"
"
Default Settings
[F] (correction value of the media feed direction): 0.00 mm
[S] (correction value of the cutting carriage movement direction): 0.00 mm
HOLD
Advanced Cutting Settings
145
4