Roland TrueVIS VG-640 User Manual page 138

Advanced Cutting Settings
D
Press [ ] or [ ] to select the cutting condition you want to set.
Set the force (pressure) of the blade. (Default setting: 50 gf )
CUT CONFIG
FORCE
Set the speed of cutting. (Default setting: 30 cm/s)
CUT CONFIG
SPEED
Set the blade offset. Enter the listed offset value for the blade. (The offset value for the included
blade is 0.25 mm (9.8 mil).) (Default setting: 0.250 mm)
CUT CONFIG
OFFSET
Set the blade's up speed during cutting (the speed at which the blade travels when it moves to the
next cutting line after cutting one cutting line). If the media comes loose during no-load feed and
the blade damages the surface of the media, reduce the speed. (Default setting: 30 cm/s)
CUT CONFIG
UP-SPEED
4
E
Press [ ] to display the screen shown below.
FORCE
50 gf
SPEED
30 cm/s 30 cm/s
OFFSET
0.250mm 0.250mm
UP-SPEED
20 cm/s 20 cm/s
F
Press [ ] or [ ] to select a value.
G
Press [ENTER] to confirm your entry.
H
Press [ ] to go back to procedure
Repeat procedure
I
Press [FUNCTION] to go back to the original screen.
136
50 gf
D
D and E to adjust respective cutting conditions.
.