Lenovo x3650 M5 Installation And Service Manual page 218

3.5" hard disk drive cage
Figure 145. 3.5-inch rear two hard-disk-drive kit cable routing
Step 6. Press down the HDD kit firmly until the HDD kit is fully seated in the connector on the system board.
Step 7. Replace the top cover (see "Replacing the top cover" on page 144).
Step 8. Slide the server into the rack.
Step 9. Reconnect the power cords and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.
Removing an EIA assembly
Use the following instructions to remove an EIA assembly for 2.5-inch and 3.5-inch models.
2.5-inch model
There are the right EIA assembly and the left EIA assembly on the server, use the following steps to remove
them.
For the right EIA assembly
1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page 289.
2. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
3. Remove the cover (see "Removing the top cover" on page 143).
206
Lenovo System x3650 M5 Installation and Service Guide
SAS signal cable