Lenovo x3650 M5 Installation And Service Manual page 544

CIM Information
Prefix: PLAT ID: 0266
User Response
1. Check system event log is showing LCD cable sensor has deasserted.
2. Reseat LCD cable on the system board.
3. Reset LCD cable on LCD panel.
4. Replace LCD cable.
• 806f011b-2502ffff : The connector [PhysicalConnectorElementName] has encountered a
configuration error. (nvDIMM 02 Cable)
This message is for the use case when an implementation has detected an Interconnect Configuration
Error.
May also be shown as 806f011b2502ffff or 0x806f011b2502ffff
Severity
Error
Serviceable
Yes
Automatically notify support
Yes
Alert Category
Critical - Other
SNMP Trap ID
50
CIM Information
Prefix: PLAT ID: 0266
User Response
If the specified sensor is front USB connector, reset the front USB cable on the system board. If
the specified sensor is front video connector, reset the front video cable in the system board. If the
specified sensor is PwrPaddle cable, complete the following steps until problem is solved:
1. Reseat the power paddle cable on the system board.
2. Replace the power paddle cable.
3. (Trained technician only) Replace the supercap n. (n = supercap number)
4. (Trained technician only) Replace the system board.
• 806f011b-2505ffff : The connector [PhysicalConnectorElementName] has encountered a
configuration error. (nvDIMM 05 Cable)
This message is for the use case when an implementation has detected an Interconnect Configuration
Error.
May also be shown as 806f011b2505ffff or 0x806f011b2505ffff
532
Lenovo System x3650 M5 Installation and Service Guide