Lenovo x3650 M5 Installation And Service Manual page 308

• One power/configuration cable (150 mm)
• One power/configuration cable (230 mm)
• One mini SAS HD Y-cable (right angle, 905/950 mm)
• One mini SAS HD Y-cable (580/590 mm)
Notes:
1. The 8x 2.5-inch hot-swap HDD assembly kit including structural parts and Tier 1 parts.
2. You will not use all cables that come with the option kit, some cables may be redundant depending
on your configuration.
To install a 8x 2.5-inch hot-swap HDD assembly kit, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 289.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 143).
Step 4. Remove the two 4-drive filler panels.
4-drive filler panel
Figure 263. Filler panels
Step 5. To obtain more working room, remove the fan cage (see "Removing the fan cage assembly" on
page 171).
Step 6. Pull the hard disk drives or fillers out of the server slightly to disengage them from the backplanes.
For more information, (see "Removing a hot-swap hard disk drive" on page 151).
Step 7. Install the new backplane in slot 2 or slot 3 depending on your configuration.Insert the backplane
tabs into slots on the bottom of the cage and push the backplane forward into the release latch (on
top of the backplane cage) until the backplane is locked in place.
Note: You can connect the cables to the drive backplane before installing the backplane onto the
cage or you can connect the cables after you install the backplane, if that is easier for you.
296
Lenovo System x3650 M5 Installation and Service Guide