Lenovo x3650 M5 Installation And Service Manual page 179

Microprocessor 2
Figure 96. DIMM connectors location
DIMM installation sequence
Depending on the server model, the server may come with a minimum of one 4 GB DIMM installed in slot
1. When you install additional DIMMs, install them in the order shown in the following table to optimize
system performance.
In general, all four channels on the memory interface for each microprocessor can be populated in any order
and have no matching requirements.
Table 11. Normal mode DIMM installation sequence
Number of installed
microprocessor
One microprocessor installed
Two microprocessors installed
For optimal performance:
Make sure all four memory channels of each microprocessor are populated. Each memory channels should
be populated with the same type and amount of memory per channel. Each microprocessor socket should
be populated with the same type and amount of memory per socket. 1DPC (one DIMM per channel) or
2DPC (two DIMM per channel) memory configuration are recommended. Unless there is a need for memory
CPU2
DIMM connector population sequence
1, 4, 9, 12, 2, 5, 8, 11, 3, 6, 7, 10
1, 13, 4, 16, 9, 21, 12, 24, 2, 14, 5, 17, 8, 20, 11, 23, 3, 15, 6, 18, 7, 19, 10, 22
Microprocessor 1
CPU1
.
Chapter 5 Removing and replacing components
167