Lenovo x3650 M5 Installation And Service Manual page 266

To install the SD adapter, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 289.
Step 2. Turn off the server, and disconnect all power cords and external cables.
Step 3. Remove the top cover (see "Removing the top cover" on page 143).
Step 4. Remove the riser-card assembly 2 (See "Removing a riser-card assembly" on page 179).
Step 5. Insert the SD cards.
Step 6. Align the SD adapter with the alignment pin and the connector; then, lower the SD adapter and
push it until it is firmly seated.
Step 7. Fasten two screws.
SD adapter
4
Figure 206. SD adapter installation
Step 8. See the http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5096845, that
comes with the option, for information about how to configure the SD adapter.
Step 9. Turn on the peripheral devices and the server.
Removing the LCD system information display panel
Use this information to remove the LCD system information display panel.
Removing the LCD panel assembly on a 3.5-inch model
To remove the LCD panel assembly on a 3.5-inch model, complete the following steps.
1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page 289.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if
necessary.
3. Remove the top cover (see "Removing the top cover" on page 143).
4. Remove the fan cage assembly (See "Removing the fan cage assembly" on page 171).
254
Lenovo System x3650 M5 Installation and Service Guide
SD 2
4
3
Connector
Alignment pin
1
SD 1