Lenovo x3650 M5 Installation And Service Manual page 271

Figure 216. LCD panel assembly cable routing
Note: To connect the LCD panel assembly cable on the system board, press evenly on the cable.
Pressing on one side of the cable might cause damage to the cable or connector.
11. Replace the top cover (see "Replacing the top cover" on page 144).
12. Slide the server into the rack.
13. Reconnect the power cords and any cables that you removed.
14. Turn on the peripheral devices and the server.
Removing the LCD system information display panel on a 2.5-inch model
To install the LCD system information display panel into a media cage that is pre-configured without a LCD
system information display panel on a 2.5-inch model, complete the following steps.
1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page 289.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if
necessary.
3. Remove the top cover (see "Removing the top cover" on page 143).
4. Remove the fan cage assembly "Removing the fan cage assembly" on page 171).
5. Remove the media cage (see "Removing the media cage" on page 175),
6. A separate bezel is needed if your media cage has a bezel without the opening and buttons for the LCD
panel, To remove the media cage bezel, complete the following steps:
a. Disengage the three snaps on the media cage bezel from the media cage. The following illustration
shows the location of three snaps.
Operator information /
LCD panel connector
Operator information /
LCD panel cable
LCD panel connector
.
Chapter 5 Removing and replacing components
259