Lenovo x3650 M5 Installation And Service Manual page 161

Handle
Figure 75. Power paddle module installation
Step 5. Replacing the power supplies (See "Replacing a hot-swap ac power supply" on page 230).
Step 6. Replacing the top cover (see "Replacing the top cover" on page 144).
Step 7. Slide the server into the rack.
Step 8. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.
Removing the front USB assembly
Use this information to remove the front USB assembly.
To remove the front USB assembly, complete the following steps.
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 289.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 143).
Step 4. Disconnect the cable on the front USB assembly from the system board.
Step 5. 1 Pull up the release latch slightly and
Power paddle assembly
2 slide the front USB assembly out of the server.
.
Chapter 5 Removing and replacing components
149