Checking, Disassembling And Servicing; Separating Engine From Tractor - wsm ME8200 Workshop Manual

ME8200, ME9000, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] SEPARATING ENGINE FROM TRACTOR

Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. Remove the radiator hose (1) from the engine side to drain the
coolant.
3. Remove the radiator cap to completely drain the coolant.
4. After all coolant is drained, reinstall the radiator hose.
Coolant Capacity
(1) Radiator Hose
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plugs (1) to drain oil.
4. After draining, screw in the drain plugs (1).
(When reassembling)
• Fill the engine oil up to the upper line on the dipstick (3).
Engine Oil Capacity
IMPORTANT
• Never mix two different type of oil.
• Use the proper SAE Engine Oil according to ambient
temperature.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick
1-S14
ENGINE
9.0 L
9.5 U.S.qts
7.9 Imp.qts
W1015370
10.7 L
11.3 U.S.qts
9.4 Imp.qts
(A) Oil level is acceptable within this
range.
W1015567
KiSC issued 03, 2007 A