wsm ME8200 Workshop Manual page 242

ME8200, ME9000, WSM
Main Speed Change Lever (Inner) and Main Speed Change Cam
1. Remove the spring pin (4), then remove the select lever (1) and
inner lever (2).
2. Remove the positioning screw (5).
3. Remove the oil seal (12) and internal snap ring (11).
4. Remove the shaft (3) and cam (7).
NOTE
• Pay attention so as not to lose the detent ball (8).
(When reassembling)
• Align the alignment mark (13) of the shaft (3) and cam (7).
(1) Select Lever
(2) Inner Lever
(3) Shaft
(4) Spring Pin
(5) Positioning Screw
(6) Spring
(7) Cam
3-S22
TRANSMISSION
(8) Ball and Spring
(9) Spring
(10) Bearing
(11) Internal Snap Ring
(12) Oil Seal
(13) Alignment Mark
W1032075
KiSC issued 03, 2007 A