Others - wsm ME8200 Workshop Manual

ME8200, ME9000, WSM

[12] OTHERS

Replacing Master Cylinder Kit and Equalizer Kit
1. Refer to "Removing Master Cylinder and Equalizer".
(See page 5-S9.)
Replacing Brake Seal 1 and 2
1. Refer to "Brake Case and Brake Disc".
(See page 5-S10.)
Bleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When water is drained from water separator.
3. When tank is completely empty.
4. After the tractor has not been used for a long period of time.
Bleeding Procedure is as Follows:
1. Make sure the fuel cock is in the "OPEN" position.
2. Open the air vent cock (2) on the fuel injection pump.
3. Pump the fuel pump knob (3) located on the top of the fuel filter.
The fuel pump knob (3) will pump easily at first and with added
resistance as air is purged from the system. To make sure air is
completely purged, pinch the fuel overflow hose (4) with fingers,
if a pulsation is felt when the knob is pumped, then, no air
remains.
4. Set the hand throttle lever at the maximum speed position, turn
on the key switch to start the engine, and then reset the throttle
lever at the mid speed (around 1500 min
If engine doesn't start, try it several times with 30 seconds
intervals.
5. Accelerate the engine to remove the small portion of air left in the
fuel system.
6. If air still remains and the engine stops, repeat the above steps.
7. Close the air vent cock (2).
IMPORTANT
• Do not hold key switch at engine start position for more than
10 seconds continuously.
needed, try again after 30 seconds.
• Always close the air vent cock except for bleeding fuel lines.
Otherwise, engine runs irregularly or stalls frequently.
(1) Fuel Cock
(2) Air Vent Cock
(3) Fuel Pump Knob
(4) Fuel Overflow Hose
G-33
G GENERAL
W1047316
W1047385
−1
(rpm)) position.
If more engine cranking is
(A) Close
(B) Open
(C) Up
(D) Down
W1047469
KiSC issued 03, 2007 A