wsm ME8200 Workshop Manual page 203

ME8200, ME9000, WSM
Center Frame
1. Disconnect the PTO control wire (4).
2. Disconnect the 2P connector (1) for PTO safety switch.
3. Disconnect the main speed change rod 2 (3) from the lever (2).
4. Remove the position and draft control lever grip (5), (6).
5. Remove the DT shift lever grip (7), auxiliary speed change lever
grip (8) and lowering speed control lever grip (9).
6. Remove the center frame (11).
7. Remove the floor mat (10).
(When reassembling)
Length of main speed
Factory spec.
change rod 2 (L)
(1) 2P Connector
(2) Lever
(3) Main Speed Change Rod 2
(4) PTO Control Wire
(5) Lever Grip
(6) Lever Grip
Step, Housing Cover and Differential Lock Pedal
1. Remove the housing cover (1).
2. Disconnect the foot accelerator rod (3).
3. Remove the step (2).
4. Disconnect the differential lock rod (6) and differential lock wire
(5).
5. Remove the differential lock pedal (4), (7).
(When reassembling)
• Be sure to adjust the differential lock pedal free travel by
adjusting the length A.
Tightening torque Step mounting screw M16
Differential lock pedal
Factory spec.
(front) free travel
(1) Housing Cover
(2) Step
(3) Foot Accelerator Rod
(4) Differential Lock Pedal (Front)
2-S21
CLUTCH
340 mm
13.39 in.
(7) DT Shift Lever Grip
(8) Auxiliary Speed Change Lever Grip
(9) Lowering Speed Control Lever Grip
(10) Floor Mat
(11) Center Frame
W1021805
117.7 to 147.1 N·m
12.0 to 15.0 kgf·m
86.8 to 108.5 lbf·ft
20.0 to 30.0 mm
0.79 to 1.18 in.
(5) Differential Lock Wire
(6) Differential Lock Rod
(7) Differential Lock Pedal (Rear)
W1022227
KiSC issued 03, 2007 A