wsm ME8200 Workshop Manual page 535

ME8200, ME9000, WSM
High Pressure Pipe 1 and Low Pressure Pipe
1. Disconnect the low pressure pipe (3) from the compressor (2)
and cap the open fittings immediately to keep moisture out of the
system.
2. Disconnect the high pressure pipe 1 (1) from the compressor (2)
and condenser.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
Low pressure pipe
mounting screw
(Compressor side)
High pressure pipe 1
Tightening torque mounting screw
(Compressor side)
High pressure pipe 1
retaining nut
(Condenser side)
(1) High Pressure Pipe 1
(2) Compressor
High Pressure Pipe 2
1. Remove the pipe clamps (3).
2. Disconnect the high pressure hose 2 (1) from the receiver (2) and
cap the open fittings immediately to keep moisture out of the
system.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
High pressure pipe 2
Tightening torque retaining nut
(Receiver side)
(1) High Pressure Pipe 2
(2) Receiver
Inner Covers
1. Remove the inner covers (1) and (2).
2. Remove the seat.
(1) Inner Cover (Upper)
10-S44
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
19.6 to 24.5 N·m
2.0 to 2.5 kgf·m
14.5 to 18.1 lbf·ft
(3) Low Pressure Pipe
W1032372
11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 lbf·ft
(3) Clamp
W1032488
(2) Inner Cover (Lower)
W1032629
KiSC issued 03, 2007 A
CABIN