Disassembling And Assembling - wsm ME8200 Workshop Manual

ME8200, ME9000, WSM

(2) Disassembling and Assembling

(A) Removing Air Conditioner Unit and Front Wiper Motor
Front Wiper Motor
1. Raise up the front wiper arm (1).
2. Turn the main switch ON.
3. Push the front wiper switch to ON position.
4. Count the number of wiper arm moving per minutes.
5. If the number differs from the factory specifications, replace the
wiper motor assembly.
Wiper arm moving at no
Factory spec.
load
(1) Wiper Arm
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to
relieve any excess
completely.
1. Stop the engine and let cool down.
2. Remove the hose (1) to drain the coolant. When removing the
drain plug, set the hose to drain port.
3. Remove the radiator cap to completely drain the coolant.
4. After all coolant is drained, reinstall the hose.
Coolant Capacity
(1) Hose
Discharging Refrigerant
1. Refer to "Discharging the System". (See page 10-S19.)
Preparation 1
1. Remove the outer roof.
2. Disconnect the battery negative cable.
3. Disconnect the A/C blower motor connector (1).
4. Disconnect the 4P connector for A/C blower resistor (2).
(1) A/C Blower Motor Connector
(2) A/C Blower Resistor
10-S40
33 to 43 times / min.
pressure before removing
9.0 L
9.5 U.S.qts
7.9 Imp.qts
(3) A/C Blower Resistor Connector
CABIN
W1027872
cap
W1024301
W1024484
W1030681
KiSC issued 03, 2007 A