wsm ME8200 Workshop Manual page 259

ME8200, ME9000, WSM
Propeller Shaft
1. Slide the propeller shaft covers (3), (5) after removing the screw
(6).
2. Tap out the spring pins (2), (4) and then slide the couplings (1),
(8) to the front and rear
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
• Tap in the spring pins (2), (4) as shown in figure.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
Fuel Tank Connection Hose
1. Remove the cover (2).
2. Remove the connection hose (1).
(When reassembling)
Tightening torque Cover mounting screw
(1) Connection Hose
Fuel Tank
1. Disconnect the wire harness (2).
2. Disconnect the fuel hoses (1).
3. Remove the fuel tanks (4).
(1) Fuel Hose
(2) Wire Harness
3-S39
TRANSMISSION
(5) Propeller Shaft Cover
(6) Screw
(7) Propeller Shaft
(8) Coupling
W1064747
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 lbf·ft
(2) Cover
W1065060
(3) Auxiliary Step
(4) Fuel Tank
W1065247
KiSC issued 03, 2007 A