wsm ME8200 Workshop Manual page 40

ME8200, ME9000, WSM
Checking Fuel Line
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
NOTE
• If the fuel line is removed, be sure to properly bleed the fuel
system.
Refer to "Bleeding Fuel System". (See page G-33.)
(1) Fuel Line
Adjusting Fan Belt Tension
CAUTION
• Be sure to stop the engine before checking belt tension.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt between pulleys.
3. If tension is incorrect, loosen the alternator mounting bolts and,
using a lever placed between the alternator and the engine block,
pull the alternator out until the deflection of the belt falls within
acceptable limits.
4. Replace fan belt if it is damaged.
Belt tension Factory spec.
(1) Belt
Adjusting Brake Pedal
1) Brake Pedal Free Travel
CAUTION
• When checking, parking the tractor on flat ground, and stop
the engine.
1. Measure the free travel by depressing the brake pedals.
2. If the measurement is not within the factory specifications, adjust
the free travel by the push rod (2).
3. After adjustment, tighten the lock nut firmly.
IMPORTANT
• Keep the free travel in the right and left brake pedals equal.
Brake pedal free travel Factory spec.
(1) Brake Pedal
(2) Push Rod
G-21
G GENERAL
(2) Clamp Band
W1040573
10 to 12 mm
0.39 to 0.47 in.
A : Check the belt tension
B : To tighten
W1040751
7 to 14 mm
0.28 to 0.55 in.
A : Free Travel
W1041022
KiSC issued 03, 2007 A